- Home
- Products
- Request
- References
- About us
- Contact
Induction heater made for Peikko Slovakia s.r.o. Kráľová nad Váhom is used for induction heating of roxor rod ends with circular cross-section up to forging temperature. It consists of input conveyer, heater box, inductor, transistor frequency converter and three-phase transformer.
The operator puts the roxor rods on the beds of the step conveyer which steps in accordance with the heating cycle. The conveyer is adjustable and it is necessary to adjust it according to the length of the heated rod. At each step the input positioner sets the required heated length. After moving through the heater the rod falls out to the chute where it is shifted by the outlet positioner so that its hot end is always in the same position regardless of the length of the roxor rod and its accuracy. After leaving the inductor the temperature of the heated end is measured by the contactless thermometer UPF IV-G. The induction heater is controlled by Programmable Logic Controller (PLC) made in Unitronics. The operation is done from the control box (placed on the press) with buttons and the communication panel. Parameters of induction heating are set on the communication panel. Moreover, all failures of the heater are displayed in text on this panel, including the instructions for troubleshooting
Heated material | magnetic steel | |
Dimensions of rods | Ø D [mm] | 10 - 20 |
length l [mm] | 155 - 750 | |
length of heated part l [mm] | 40 - 80 | |
Output [kW] | 120 | |
Maximum heated amount (for Ø 80) [pcs/h] | 450 | |
Rated output temperature of heated rod end [°C] | 1100 |
10.12.2020 Thank you for your cooperation in 2020 and wish you many personal and work achievements in 2021. ROBOTERM Chotěboř wishes you a Merry Christmas and Happy New Year 2021! more...
20.2.2020 Induction annealing machines are designed for heat treatment of welded joints to... more...
10.12.2019 Thank you for your cooperation in 2019 and wish you many personal and work achievements in 2020. ROBOTERM Chotěboř wishes you a Merry Christmas and Happy New Year 2020! more...
27.6.2019 The world's largest event in the field of heating and processing metals The Bright World of Metals 2019, held from 25th to 29th June 2019, opened its gates again after not being held for four years. more...
10.12.2018 Thank you for your cooperation in 2018 and wish you many personal and work achievements in 2019. ROBOTERM Chotěboř wishes you a Merry Christmas and Happy New Year 2019! more...
23.4.2018 Induction heater made for Řetězárna Česká Třebová Ltd. is used for induction heating of blanks „L" 700 ÷ 1300 mm up to forging temperature. It consists of input and output mechanisms, a heater box, more...
Induction heating technology is particularily advantageous for spot and surface
more...We provide repass, repairs and reconditioning of induction heaters, frequency converters, inductors ...
more...Feeding systems handle the manipulation of billets to the entrance of an inductor
more...Induction annealing machines are designed for heat treatment of welded joints to...
more...Induction heating can be simulated very precisely by computer technology. ...
more...Thyristor Frequency Converters used in induction heating, hardening, smelting.
more...